[. . . ] Do not insert fingers or foreign objects into the intake or air outlet. When removing the power plug, always hold the plug and never pull the cord. Remove the power plug from the wall outlet before cleaning the unit and when not using the unit. Electrical shock from bad insulation and / or fire from short circuit may occur as a result. [. . . ] If operation is set to ON during this time, the CLEAN-SIGN LIGHT will alternately flash in green, orange and red. When the Plasmacluster ion operation is in Clean Mode, or in AUTO Plasmacluster Ion Mode and the air in the room is impure, the light will activate and the unit will operate in Clean Mode. When the Plasmacluster ion operation is in the Ion Control Mode, or in AUTO Plasmacluster Ion Mode and the air in the room is clean, this light will activate and the unit will operate in Ion Control Mode. The light can be turned off by using the `Lights ON/OFF Button' on the Remote Control. The condition of the CLEAN-SIGN depends on the room air condition ABOUT THE CLEAN-SIGN the plug is inserted into the wall outlet. Thepossible to of theaCLEAN-SIGN depends on the room air condition · It is condition have green CLEAN-SIGN with impurities in the air at the detected by air Odor Sensor when the plug is inserted environment. After time that thethe purifier was just introduced to the room into the wall outlet. It while, however, thea green CLEAN-SIGN with impurities detect air at the a is possible to have base impurity rate will be adjusted to in the room air time that correctly. A while, however, ON/OFF impurity on the remote control detect roomthe Use the Display the base Button rate will be adjusted to to turn off air conditon light. Use the Lights ON/OFF Button on the remote control to turn off the Indicator light. When you press the POWER ON/OFF Button, a short beep will sound and operation will start in AUTO Mode. Unless unplug the power cord, the operation starts in the previous mode the unit was operated in. 1 hour Cancel 4hours 8 hours The unit will stop operation when the timer is up. When pressed, the unit will switch between Clean Mode and the Ion Control Mode automatically depending on the amount of impurities in the air as detected by the odor sensor. Clean Mode will operate for 1 minute when the Auto function is selected. When pressed, the unit will constantly operate in the Clean Mode, in which the same numbers of positive and negative ions are discharged. To maintain optimum performance of this air purifier, please clean the unit including the sensor and filters periodically. When cleaning the unit, be sure to unplug the power cord, and never handle the plug with wet hands. Washing will not improve filter performance, and it may even cause electric or malfunction. To prevent dirt or stains on the main unit, clean as often as necessary. Wipe with a dry, soft cloth For stubborn stains or dirt, use a soft cloth dampened with warm water. Keep the unit away from water The sensitivity of the sensor will become unstable if the odor sensor is dirty or blocked. [. . . ] The condition of the CLEAN-SIGN depends on the room air condition INFORMAZIONI SULLA when the plug is inserted into the wall outlet. It is possible to have a green CLEAN-SIGN with dipende dalle condizioni dell'aria the air purifier was just sensore degli odori quando si inserisce time thatdella stanza rilevate dalintroduced to the room environment. The condition of the CLEAN-SIGN depends on the room air condition BETREFFENDE DE ZUIVERHEIDSAANDUIDING Detected by the Odor Sensor when the plug is inserted into the wall outlet. de zuiverheidsaanduiding is afhankelijk van de luchttoestand in de · It is possible to have a green CLEAN-SIGN with impurities in the air at the kamer zoals die wordt waargenomen door de geursensor wanneer time that the air purifier was just introduced to the room environment. [. . . ]